A representative of the Technical Committee visited the main repeater site on Friday, 11/11. The repeater controller was re-initialized using special software from the vendor then had the firmware and our configuration reloaded. As of this writing, all seems well.
The recorded announcements were not reloaded due to a "connector failure" (as in the TechComm rep did not have the correct adapter!) so those will be added back at a later date.
The TechComm is still very interested in user reports especially if the repeater is heard to reset itself. When the controller resets, it announces that it is an RC-210, reads its firmware version, then tells the world that it is "ready".
Again, the committee wishes to thank the membership for its patience!